1. .华南农业大学公共基础课实验教学中心,广东,广州,510642
2.
3. 华南农业大学理学院,广东,广州,510642
纸质出版日期:2014,
网络出版日期:2014-1-25,
扫 描 看 全 文
陈如麒, 徐初东, 朱贵文. Bi1.6La0.4Ti2O7 薄膜的制备及性能研究[J]. 中山大学学报(自然科学版)(中英文), 2014,53(1):78-82.
CHEN Ruqi, XU Chudong, ZHU Guiwen. Preparation and Properties of Bi1.6La0.4Ti2O7[J]. Acta Scientiarum Naturalium Universitatis SunYatseni, 2014,53(1):78-82.
采用化学溶液沉积法在ITO基片上制备不同退火温度的掺镧钛酸铋Bi
1.6
La
0.4
Ti
2
O
7
(BLT)薄膜。研究了其结构、介电性能、漏电流密度与外加电压 I-V 关系曲线和光学带隙。XRD射线衍射测试结果表明,经500、550、600 ℃ 1 h退火后的薄膜的主晶相为烧绿石结构,无杂相生成,600 ℃时BLT薄膜衍射峰比其他两种温度的强。在1 kHz频率下测得的介电常数、损耗因子分别为114,3%;129,3%;194,6%。BLT薄膜的漏电流密度与外加电压关系曲线表明,BLT薄膜600 ℃的漏电流比550和500 ℃稍微减小。通过透射谱分析得到BLT薄膜的光学带隙几乎不受温度影响,均为3.7 eV。这些结果表明制备BLT固溶体薄膜较佳为退火温度600 ℃,具有较好的性能,在光电器件有良好的应用前景。
Bi
1.6
La
0.4
Ti
2
O
7
(BLT) thin films were prepared on ITO glass substrates using a chemical solution deposition method. Their structures
dielectric properties
current-voltage I-V curves and optical constants were analyzed. The result of X-ray diffraction (XRD) analysis showed that the thin films annealed at 500
550 and 600 ℃ for 1h were grown in pyrochlore structure and no secondary phase was detected. Also
the XRD peaks of BLT annealed at 600 ℃ was stronger than those annealed at other temperatures. The dielectric constant and dissipation factor (at 1 kHz) were 114 and 3%
129 and 3%
194 and 6%
respectively
for films annealed 500
550 and 600 ℃. Leakage current densities of BLT thin films versus applied voltage curves suggested that the value of leakage current for films annealed at 600 ℃ was much smaller than those annealed at 500 and 550 ℃. The annealing temperature had little effect on the optical band gap of the films with the values of 3.7 eV. These results indicated that the BLT thin films annealed at 600 ℃ had an excellent property
and they had a potential application in opticoelectric devices.
化学溶液沉积法Bi1.6La0.4Ti2O7光学带隙介电
0
浏览量
338
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构