浏览全部资源
扫码关注微信
Simulation of pyrolysis physical field and temperature optimization of the encapsulating materials of decommissioned Cu（InGa）Se2 photovoltaic laminated module
- Acta Scientiarum Naturalium Universitatis Sunyatseni Vol. 63, Issue 3, Pages: 154-162(2024)
- 作者机构：
中山大学环境科学与工程学院，广东 广州 510006
- 作者简介：
- 基金信息：
DOI：10.13471/j.cnki.acta.snus.ZR20240039
CLC： X705Published：25 May 2024，
Published Online：01 April 2024，
Received：23 February 2024，
Accepted：04 March 2024
扫 描 看 全 文
黄智豪,巫宇森,秦保家等.退役Cu（InGa）Se2光伏层压件封装材料热解物理场模拟及温度优化[J].中山大学学报(自然科学版)(中英文),2024,63(03):154-162.
HUANG Zhihao,WU Yusen,QIN Baojia,et al.Simulation of pyrolysis physical field and temperature optimization of the encapsulating materials of decommissioned Cu（InGa）Se2 photovoltaic laminated module[J].Acta Scientiarum Naturalium Universitatis Sunyatseni,2024,63(03):154-162.
黄智豪,巫宇森,秦保家等.退役Cu（InGa）Se2光伏层压件封装材料热解物理场模拟及温度优化[J].中山大学学报(自然科学版)(中英文),2024,63(03):154-162. DOI： 10.13471/j.cnki.acta.snus.ZR20240039.
HUANG Zhihao,WU Yusen,QIN Baojia,et al.Simulation of pyrolysis physical field and temperature optimization of the encapsulating materials of decommissioned Cu（InGa）Se2 photovoltaic laminated module[J].Acta Scientiarum Naturalium Universitatis Sunyatseni,2024,63(03):154-162. DOI： 10.13471/j.cnki.acta.snus.ZR20240039.
摘要
在氮气氛围下，研究了不同热解温度时退役
<math id="M1"><mi mathvariant="normal">C</mi><mi mathvariant="normal">u</mi><mo stretchy="false">(</mo><mi mathvariant="normal">I</mi><mi mathvariant="normal">n</mi><mi mathvariant="normal">G</mi><mi mathvariant="normal">a</mi><mo stretchy="false">)</mo><mi mathvariant="normal">S</mi><msub><mrow><mi mathvariant="normal">e</mi></mrow><mrow><mn mathvariant="normal">2</mn></mrow></msub></math>
https://html.publish.founderss.cn/rc-pub/api/common/picture?pictureId=59485172&type=
3.89466691
https://html.publish.founderss.cn/rc-pub/api/common/picture?pictureId=59485187&type=
16.59466553
光伏层压件封装材料的气态产物组成及各组分的生成行为。以节能降碳为控温依据，选取467 ℃为目标热解温度，并以438
o
C和497 ℃为对照温度，进行建模分析和模型验证。通过热-流复合物理场模拟，优化调整后的实际目标、对照热解温度为490、465和525 ℃。可以发现，将目标热解温度467 ℃调整至490 ℃后可将平均温度误差由57.18 ℃减小至5.76 ℃，下降约89.93%。在490、465和525 ℃温度下，当热解温度进入200 ℃以上的高温区间时，平均误差分别仅为3.62、4.72和3.29 ℃。这表明所建立的模型在高温区间内具有良好的准确性和指示作用。
Abstract
The composition and formation behavior of each component of decommissioned
<math id="M2"><mi mathvariant="normal">C</mi><mi mathvariant="normal">u</mi><mo stretchy="false">(</mo><mi mathvariant="normal">I</mi><mi mathvariant="normal">n</mi><mi mathvariant="normal">G</mi><mi mathvariant="normal">a</mi><mo stretchy="false">)</mo><mi mathvariant="normal">S</mi><msub><mrow><mi mathvariant="normal">e</mi></mrow><mrow><mn mathvariant="normal">2</mn><mtext> </mtext></mrow></msub></math>
https://html.publish.founderss.cn/rc-pub/api/common/picture?pictureId=59485189&type=
4.57200003
https://html.publish.founderss.cn/rc-pub/api/common/picture?pictureId=59485193&type=
19.72733307
module encapsulating materials at different pyrolysis temperature under nitrogen atmosphere were studied. In order to save energy and reduce carbon emissions，467 ℃ was selected as the target pyrolysis temperature，while 438 ℃ and 497 ℃ were chosen as the control temperature. Simulation of thermal-flow compound
physical field and model verification were conducted. And the actual target pyrolysis temperature and control temperature were adjusted to 490，465 and 525 ℃. It was found that when temperature was adjusted from 467 to 490 ℃，the average temperature error of pyrolysis can be reduced from 57.18 ℃ to 5.76 ℃，which was reduced by 89.93%. At the temperature of 490，465 and 525 ℃，when the temperature is above 200 ℃，the average errors were only 3.62，4.72 and 3.29 ℃. It shows that the model has good accuracy and indicating effect in high temperature range.
关键词
退役<math id="M3"><mi mathvariant="normal">C</mi><mi mathvariant="normal">u</mi><mo stretchy="false">(</mo><mi mathvariant="normal">I</mi><mi mathvariant="normal">n</mi><mi mathvariant="normal">G</mi><mi mathvariant="normal">a</mi><mo stretchy="false">)</mo><mi mathvariant="normal">S</mi><msub><mrow><mi mathvariant="normal">e</mi></mrow><mrow><mn mathvariant="normal">2</mn></mrow></msub></math>https://html.publish.founderss.cn/rc-pub/api/common/picture?pictureId=59485179&type=3.89466691https://html.publish.founderss.cn/rc-pub/api/common/picture?pictureId=59485180&type=16.59466553光伏层压件封装材料热解节能降碳
Keywords
decommissioned <math id="M4"><mi mathvariant="normal">C</mi><mi mathvariant="normal">u</mi><mo stretchy="false">(</mo><mi mathvariant="normal">I</mi><mi mathvariant="normal">n</mi><mi mathvariant="normal">G</mi><mi mathvariant="normal">a</mi><mo stretchy="false">)</mo><mi mathvariant="normal">S</mi><msub><mrow><mi mathvariant="normal">e</mi></mrow><mrow><mn mathvariant="normal">2</mn></mrow></msub></math>https://html.publish.founderss.cn/rc-pub/api/common/picture?pictureId=59485213&type=4.57200003https://html.publish.founderss.cn/rc-pub/api/common/picture?pictureId=59485199&type=19.30400085 photovoltaic laminated moduleencapsulating materialpyrolysisencapsulating material
references
褚家宝， 2009. 铜铟镓硒（CIGS）薄膜太阳能电池研究［D］. 上海： 华东师范大学.
何睿， 2009. 基于红外光谱吸收原理的二氧化碳气体检测系统的设计与实验研究［D］. 吉林： 吉林大学.
赵江英， 王刚， 2018. 废旧晶硅太阳能组件回收技术的发展现状［J］. 再生资源与循环经济， 11（6）： 29-31.
BERGER W， SIMON F， WEIMANN K， et al， 2010. A novel approach for the recycling of thin film photovoltaic modules［J］. Resour Conserv Recy， 54： 711-718.
BOHLAND J， ANISIMOV I， 1997. POSSIBILITY of recycling silicon PV modules［C］//IEEE Photovolt Spec Conf.IEEE： 1173-1175.
BOMHARD E M，2020. The toxicology of gallium oxide in comparison with gallium arsenide and indium oxide［J］. Environ Toxicol Pharmacol， 80： 103437.
DENG R， CHANG N L， OUYANG Z， et al， 2019. A techno-economic review of silicon photovoltaic module recycling［J］. Renew Sustain Energy Rev， 109：532-550.
DIAS P， JAVIMCZIK S， BENEVIT M， et al， 2017. Recycling WEEE： Polymer characterization and pyrolysis study for waste of crystalline silicon photovoltaic modules［J］. Waste Manag， 60： 716-722.
DONI A， DUGHIERO F， 2012. Electrothermal heating process applied to C-Si PV recycling［J］.IEEE Photovolt Spec Conf. IEEE： 757-762.
ELSHKAKI A， GRAEDELT， 2013. Dynamic analysis of the global metals flows and stocks in electricity generation technologies［J］. J Clean Prod， 59： 260-273.
ESCALONA P E， ZECCHINA A， 1987. IR-Spectroscopic investigation of ethylene oxide adsorption and polymerization on MgO［J］. J catal， 104： 299-306.
FELICIA S， JOSEF V， PETER R， et al， 2017. Response-surface fits and calibration transfer for the correction of the oxygen effect in the quantification of carbon dioxide via FTIR spectroscopy ［J］. Anal Chim Acta， 972： 16-27.
FIARRELL C， OSMAN A I， ZHANG X， et al， 2019. End-of-life of silicon PV panels： A sustainable materials recovery process［J］. Waste Manag， 84： 91-101.
LI X， MA B， WANG C， et al， 2023. Recycling and recovery of spent copper-indium-gallium-diselenide （CIGS） solar cells： A review［J］. Int J Miner Metall Mater， 30： 989-1002.
LU M， RUNT J， PAINTER P， 2009. An infrared spectrocopic study of a polyester copolymer ionomer based on poly（ethylene oxide）［J］. Macromolecule， 42： 6581-6587.
MARWEDE M， BERGER W， SCHLUMMER M， et al， 2013. Recycling paths for thin-film chalcogenide photovoltaic waste-current feasible processes［J］. Renew Energy， 55： 220–229.
NASSAR N T， WILBURN D R， GOONAN T G， 2016. Byproduct metal requirements for U.S. wind and solar photovoltaic electricity generation up to the year 2040 under various clean power plan scenarios［J］. Appl Energy， 183： 1209-1226.
PAGNANELLI F， MOSCARDINI E， GRANATA G， et al， 2017. Physical and chemical treatment of end of life panels： An integrated automatic approach viable for different photovoltaic technologies［J］. Waste Manag， 59： 422-431.
PALITZSCH W， LOSER U， 2012. Economic PV waste recycling solutions -results from R&D and practice［R］. Conference Record of the IEEE Photovoltaic Specialists Conference： 628-631.
RIECH I， CASTRO-MONTALVO C， WITTERSHEIM L， et al， 2021. Experimental methodology for the separation materials in the recycling process of silicon photovoltaic panels［J］. Materials， 14（3）： 581.
ŠTEPÀN P， LUDKA M， FRANTIŠEK R， 2007. Adsorption of poly（ethylene oxide）-block-polylactide copolymers on polylactide as studied by ATR-FTIR spectroscopy［J］. J Colloid Interf Sci， 308： 291-299.
WANG X， TIAN X， CHEN X， et al， 2022. A review of end-of-life crystalline silicon solar photovoltaic panel recycling technology［J］. Sol Energy Mater Sol Cells， 248：111976.
ZHOU Y， LI J， RECHBERGER H， et al， 2020. Dynamic criticality of by-products used in thin-film photovoltaic technologies by 2050［J］. J Clean Prod， 263：121599.
0
Views
3
下载量
0
CSCD
- L-PDFDownload
- Meta-XMLDownload
- BibTeXDownload
- EndnoteDownload
- RefMan Download
- NoteExpressDownload
- NoteFirstDownload
Publicity Resources
Related Articles
Related Author
Related Institution
- Postal code：510275
- Tel：020-84112585，84113223 Email：xuebaozr@mail.sysu.edu.cn
- Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09064830号-19
京公网安备11010802024621 - It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
- Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.
